Schneider Electric Altivar 58 VW3-A58101 Manual do Utilizador descarregar pdf (Página 18)

ALTIVAR



58 Keypad Display VVDED397047US R8/01

Chapter 1 — Overview 08/01

Total Unlock Position – All modes: this level is used during

startup for access to advanced setup parameters.

• You can do everything listed in both access levels above.

• You can also select a different macro-configuration in the MACRO-

CONFIG menu.

• You can adjust the performance of the motor-drive controller system,

in the 3—DRIVE menu.

• You can configure the drive controller command to be either from the

terminal strip, the keypad display, or the integrated serial link using the

4—CONTROL menu.

• You can change the assignments of the inputs and outputs in the

5—I/O menu.

• You can configure motor protection, drive controller protection, and

response after a fault has occurred in the 6—FAULT menu.

• You can save the drive controller configurations, recall them from

memory, return to factory settings, or protect your configuration in the

7—FILES menu.

• You can adjust the parameters pertaining to communication in the 8—

COMMUNICATION menu, if a communication card is installed.

• You can access the 8—APPLICATION menu, if a customer

application card is installed.

Access To Menus

The number of menus which can be accessed depends on the position of

the access locking switch. Each menu contains parameters to be

adjusted or configured. Figure 6 shows the menus as they appear on the

display when the access locking switch is in the Total Unlock Position.

NOTE: If an access code (password) has already been programmed,

certain menus may not be modifiable, or may not be visible. In this case

refer to “Access Code” on page 81 for how to enter the access code.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Sem comentários

Schneider Electric Altivar 58 VW3-A58101 Manual do Utilizador Página 18