Schneider Electric Modbus Plus Network Bridge Multiplexer none Manual do Utilizador descarregar pdf (Página 20)

ProWORX NxT User’s Guide

54 l Performing a network scan

Below are the features specific to scanning a TCP/IP network:

Ÿ IP Addr: The first three octets of the address of the controller for which

you want to scan. Type the address using the decimal dotted IP

Address format (for example, 3.58.157).

Ÿ Next Area: Click to increment the third decimal dotted value by one.

By default, the scan range is not enabled. If the scan range isn’t set

when you click Next Area, the scan range is based on your computer

address and 1 through 255.

Ÿ Setup: Click to set a specific scan range of IP Addresses in the

Network Scan TCP/IP Setup dialog box. By setting a range, you can

finely tune the scanning for optimum performance.

Below are the features of the Network Scan TCP/IP dialog box:

Ÿ Use scan range: Select to use the scan range setting. By default, it’s

cleared.

Ÿ Scan Range From: The address from which a scan will begin and

increments by one point in the third dotted decimal value each time

Next Area is clicked.

Ÿ Scan Range To: The address value that will be last scanned before

starting again at the Scan Range From value when Next Area is

clicked.

v For more information on scanning the network, see “Performing a

network scan” on page52.

To reduce the scan time, limit the range of IP addresses to the smallest amount

necessary to cover the Schneider Ethernet devices on the network.

In the example shown, the scan is

set to begin at 3.58.157.1 and end

at 3.58.157.95.

When Next Area is clicked in the

Network Scan dialog box, the scan

begins at 3.58.158.1 and contin-

ues until 3.58.158.95 is reached.

1 2 ... 15 16 17 18 19 20

Sem comentários

Schneider Electric Modbus Plus Network Bridge Multiplexer none Manual do Utilizador Página 20