Schneider Electric Modbus Plus Network Bridge Multiplexer none Especificações descarregar pdf (Página 21)

Bulletin No. VVDED397044US R12/00 Section 1—Installation & Configuration

December 2000 Hardware Setup

Figure 12: Terminal Locations (Product Frame Size 7)

Cable Routing Practices

When wiring the ATV58 drive controllers to a MODBUS PLUS network,

follow all wiring practices required by national and local electrical codes.

Observe the following guidelines:

• Avoid areas of high temperature, moisture, vibration, or other

mechanical stress.

• Secure the cable where necessary to prevent its weight and the weight

of other cables from pulling or twisting the cable.

• Use cable ducts, raceways, or other structures to protect the cable.

Use these structures for signal wiring paths. They should not contain

power wiring.

Control Terminals

Power Terminals

Ground Terminal

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Sem comentários

Schneider Electric Modbus Plus Network Bridge Multiplexer none Especificações Página 21