Schneider Electric Modbus Plus Network Bridge Multiplexer none Guia de Instalação Página 241

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 261
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 240
Installing Custom Cable Systems
890 USE 100 00
229
D .7.4 Identifying the Terminals
Refer to Figure 99. Remove the screw that secures the connector cap.
Remove the cap to expose the wiring terminals. Note the terminal
numbers (1, 2, 3) marked on each side of the connector.
Caution: The connector terminals have sharp edges. Use
caution when handling the connector .
TOP SIDE
(COVER REMOVED)
Figure 99 Identifying the Terminals
D .7.5 Connecting the W ires
Refer to Figure 100. All wires will be routed into one side of the
connector. The wiring direction depends upon the type of device to be
installed at the site, as shown in the figure. If a device is not listed, the
wires can be routed into either side of the connector.
Vista de página 240
1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 260 261

Comentários a estes Manuais

Sem comentários